Welcome to visit us!

[email protected]

Low Alumina Iron Ore Sinter Properties

Apr 23, 2010 Due to depletion of high grade iron ore resources, alumina content in the iron ore fines is expected to increase gradually. Ore with higher alumina content is usually expected to be detrimental in forming the sinter matrix, if sintered alone, due to the low reactivity of alumina bearing minerals and the high viscosity of primary melts.

Get Price

News& Blog

  • Influence Of Alumina On Iron Ore Sinter Properties And

    Influence Of Alumina On Iron Ore Sinter Properties And

    Apr 23, 2010 Due to depletion of high grade iron ore resources, alumina content in the iron ore fines is expected to increase gradually. Ore with higher alumina content is usually expected to be detrimental in forming the sinter matrix, if sintered alone, due to the low reactivity of alumina bearing minerals and the high viscosity of primary melts.

    Read Moreleft_2
  • Effect Of Raw Material Composition On The Sintering

    Effect Of Raw Material Composition On The Sintering

    The sinters made from the low alumina commercial iron ores A 1, A 4, B 1 presented the higher tumbler strength JIS TI 5461 and the lower coke rate 4552kgt sinter, and required the lower mois-ture 5.86.2mass. However, the RDI was not simply re-lated to the alumina level of iron ore. The sinter made from the high alumina ore D

    Read Moreleft_2
  • Mineralogy Of Iron Ores Of Different Alumina Levels From

    Mineralogy Of Iron Ores Of Different Alumina Levels From

    May 07, 2015 also important because of its influence on particle surface roughness. Low ore porosity and the presence of libe-rated and fine quartz particles, are beneficial to sinter physical and mechanical properties. As the ore contains less alumina less of it will go to sinters molten part to form multi-component hematite or

    Read Moreleft_2
  • Influence Of Alumina On Iron Ore Sinter Properties And

    Influence Of Alumina On Iron Ore Sinter Properties And

    The low Al2O3 2.0 wt, medium MgO 2.02.5 wt and high basicity 3.0 sinter showed higher low temperature degradation index LTD due to the presence of silico ferrites of calcium and ...

    Read Moreleft_2
  • Review Effects Of Alumina On Sintering Performance Of

    Review Effects Of Alumina On Sintering Performance Of

    pacts of alumina on the sintering performance of hematite iron ore nes are discussed. 2. Effect of Alumina on Sinter Mineralogy Low temperature uxed sinter mainly contains un-re-acted hematite nuclei around 30vol in a matrix about 70vol consisting of silicoferrite of calcium and alu-minium SFCA, secondary hematite H2, secondary mag-

    Read Moreleft_2
  • Iron Ore Sintering Part 2 Quality Indices And

    Iron Ore Sintering Part 2 Quality Indices And

    strength and quality of sinter deteriorate as the alumina content rises. Alumina promotes the formation of SFCA, which is beneficial for sinter strength, but the strength of the ore components is lower, since a high alumina content in their lattice has been reported to be the main cause of the observed lower strength 5,6. Alumina increases

    Read Moreleft_2
  • Influence Of Sinter Basicity Caosio 2 On Low And High

    Influence Of Sinter Basicity Caosio 2 On Low And High

    The low alumina sinter showed higher productivity and strength, and lower RDI due to the presence of higher silico ferrites of calcium and aluminium SFCA and magnetite phase, and lower pore ...

    Read Moreleft_2
  • Sinter Quality And Process Of Sintering Iron Ores Ispatguru

    Sinter Quality And Process Of Sintering Iron Ores Ispatguru

    Nov 21, 2014 The size of iron ore affects the sintering properties. An increase in the size of iron ore promotes the productivity of sinter, but can reduce the tumbler strength slightly and save a little coke. The mineralogy of sinter can more easily be predicted from its chemical composition than its physical and chemical properties.

    Read Moreleft_2
  • Iron Ore Sinter An Overview Sciencedirect Topics

    Iron Ore Sinter An Overview Sciencedirect Topics

    Low-temperature 1300 C iron ore sinter is an agglomerate of unmelted and partially melted nuclei particles 1 mm and a matrix bonding phase produced from the melting of fine ore 1 mm and flux particles, with the majority of melt formation occurring in the granule adhering fines layer. The majority of nuclei are hematitic, but they can also be any other unreacted particles such as flux or

    Read Moreleft_2
  • Effect Of Iron Ore Concentrate On Sintering Properties

    Effect Of Iron Ore Concentrate On Sintering Properties

    iron ore concentrate contains a lower alumina. Recently it is more popular to be applied in commercial sinter plants to decrease the alumina content in sinter or combined with a high alumina low grade ore to reduce the production cost of sintering. However the productivity of sinter decreased with a decrease in the size of iron ore.

    Read Moreleft_2
  • Sintering And Heating Reduction Processes Of Alumina

    Sintering And Heating Reduction Processes Of Alumina

    Abstract. Alumina containing iron ore samples 0 75 5Al 2 O 3 were sintered in a down draft sinter pot.The structures of the produced sinters were microscopically examined and the different phases developed were identified.

    Read Moreleft_2
  • Pdf Iron Ore Sintering Venkata Krishnaiah Academiaedu

    Pdf Iron Ore Sintering Venkata Krishnaiah Academiaedu

    Alumina promotes the formation of SFCA, sintering determine the structure of the bonding which is beneicial for sinter strength, but the strength of phases originated in the sinter. The melt properties in the ore components is lower, since a high alumina content the moments prior to solidiication depend to a large in their lattice has been ...

    Read Moreleft_2
  • Effect Of Alumina And Magnesia On Microstructure And

    Effect Of Alumina And Magnesia On Microstructure And

    The low Al 2 O 3 2.0 wt, medium MgO 2.02.5 wt and high basicity 3.0 sinter showed higher low temperature degradation index LTD due to the presence of silico ferrites of calcium and aluminium SFCA, and magnetite phase, and lower pore phase as compared to low basicity iron ore sinter.

    Read Moreleft_2
  • Iron Ore Sintering Part 2 Quality Indices And

    Iron Ore Sintering Part 2 Quality Indices And

    order to improve the RDI without altering other sinter properties 4. 2.1.2. Al 2 O 3 sinter The most harmful effect of alumina is to worsen the sinter RDI, which increases as the alumina content rises. Industrial experience with the blast furnace shows that ... The iron ore used presents a low MgO content 0.01 and a high Al 2 O 3 content ...

    Read Moreleft_2
  • Characterisation Of Iron Ore Sinter And Its Behaviour

    Characterisation Of Iron Ore Sinter And Its Behaviour

    Abstract. Egyptian iron ore sinter with low contents of barite 0 5 wt-BaO and alumina 0 7 wt-Al 2 O 3 was prepared by the down draft sinter pot technique and physically and chemically characterised.The sinter is mainly composed of unassimilated hematite, precipitated hematite and magnetite phases and glassy calcium silicate slag.

    Read Moreleft_2
  • Specifications Guide Iron Ore Sampp Global

    Specifications Guide Iron Ore Sampp Global

    Iron Ore Alumina Differential per 1 with 2.5-4 60-63.5 Fe Fines IOALE00 IOALE03 Assessment Daily PMA1105 1 alumina within 2.5-4 range for fines with 60-63.5 Fe dmt Iron Ore Alumina Differential per 1 with 5 55-60 Fe Fines TSIAF00 TSIAF03 Assessment Daily PMA1105 1 alumina below 5 for fines with 55-60 Fe dmt

    Read Moreleft_2
  • Microstructure And Minerals Evolution Of Iron Ore

    Microstructure And Minerals Evolution Of Iron Ore

    domestic iron ore concentrates, which helps to produce sinter with lower impurity levels. However, an excessively low SiO2 content would lead to insufficient generation of SFCA Quaternary compound of calcium ferrite containing silicate and alumina under the same basicity mass ratio of CaO to SiO2 in sinter.

    Read Moreleft_2
  • Microstructure And Minerals Evolution Of Iron Ore Sinter

    Microstructure And Minerals Evolution Of Iron Ore Sinter

    However, the high utilization of imported iron ores has also given rise to some problems. Iron ores containing a high content of Al 2 O 3 make up relatively higher proportions of those imported, though these have been verified to have adverse effects on the quality and metallurgical properties of sinter 3,4.Moreover, the SiO 2 content in imported iron ores is relatively lower than that of ...

    Read Moreleft_2
  • Chemical Mineralogical And Metallurgical

    Chemical Mineralogical And Metallurgical

    Goethite Rich Iron Ore Sinter Dr. Kalpataru Rout Sr. Manager, Quality Control Laboratory, NINL, Duburi, Jajpur, Odisha 755026, India. Krout1161gmail.com Abstract In this paper the influence of structural water present in goethite rich ore fines on sinter properties like mean size, RI, RDI, TI, AI and microstructure were studied.

    Read Moreleft_2
  • Effect Of B2o3 Content On The Sintering Basic

    Effect Of B2o3 Content On The Sintering Basic

    The sintering basic characteristics of iron ore play a key role in the process of sintering. In this study, the effects of B 2 O 3 on the assimilation characteristics, softening temperature, fluidity of liquid phase, compressive strength of bonding phase, and microstructure of the mixed fine powder of hematite and vanadium-titanium magnetite H-VTM are studied.

    Read Moreleft_2
  • Effect Of Alumina And Its Types On Sintering Performance

    Effect Of Alumina And Its Types On Sintering Performance

    In addition, the addition of Al2O3 also adversely affects the metallurgical performance of sinter products. However, the effect of various types of alumina present in iron ore fines on sintering performances and metallurgical properties of sinter is different.

    Read Moreleft_2
  • Influence Of Coating Granulation Process On Iron Ore

    Influence Of Coating Granulation Process On Iron Ore

    Aug 20, 2010 Usually limonitic and goethite ore are associated with higher alumina and LOI. The conventional sintering process is one of the well established processes for high quality hematite ore. It does not fully respond to the low grade iron ore associated with goethite and limonite. This has led to deterioration in sinter properties and productivity.

    Read Moreleft_2
  • Optimising Iron Ore Sinter Leads To Cost Savings Csiro

    Optimising Iron Ore Sinter Leads To Cost Savings Csiro

    Variation in ore characteristics . Alumina-containing iron ores are major feed materials used in iron ore sintering in the Asia Pacific region. There are three main types of alumina-containing iron ores and due to their unique properties they perform differently during the sintering process.

    Read Moreleft_2
  • Effect Of Raw Material Composition On The Sintering

    Effect Of Raw Material Composition On The Sintering

    2 and MgO, the sintering properties varied with iron ore type greatly. The sinters made from the dense low alumina iron ores presented the higher tumbler strength and the lower coke rate, but the RDI was not simply related to the alumina level of iron ore. A high alumina ore may produce the sin-ter with a very low or very high RDI.

    Read Moreleft_2